Power supply fan will not spin.
If the power supply fan not spinning, then the problem is too much dust over the fan, so annoying fan rotation. Electricity is not strong enough to move the dirt.
And actions to be taken is to clean the fan from the dust.

Power supply does not provide electrical power.
If the power supply does not provide electrical power, then the problem is broken or a fuse burning component
So the solution is to replace the fuse with an appropriate fuse. Be careful to do the replacement, because usually fuses mounted die, and to remove it to use solder.
IDE power cable less.
If the IDE power cable is less, the problem is that you use too many components, so that the cable supplied by the power supply is less. For example, you use two hard drives, one CD-ROM, a DVD-RW, and one hard drive mobile rack.
And the solution is buy one Y cable, which serves to hold a power cable plugs. Typically, the available Y cable is a cable for IDE peripherals.


Casing cover can not be closed perfectly.
If the casing cover can not be closed perfectly, the problem is there is a curved hook or lock himself a crooked lid.
And the solution is to straighten the hooks or locking plates which are bent. Do not forcibly close the casing. Crooked usually occurs when the chassis cover installed imperfectly or imposed on the chassis frame.

Closing nyetrum casing.
If nyetrum casing cover, the problem is electrical current leakage from the power supply.
The solution is to use a cable to connect the body casing with ground (ground or wall).

Indicator lights on the front panel is not lit.
If the indicator light on the front panel is not lit, the problem is the indicator light is off or one set of indicators cables connected to the motherboard.
The solution is check the cable connection is connected to indicator motherboard,. The directions are usually found on the motherboard's manual. There are several indicator lights that usually there is in the front panel, the power indicator lamp, indicator light IDE, floppy and indicator lights.

The temperature inside the casing is too high.
If the temperature inside the casing is too high, the problem is in the air circulation is not good, the fans are not working normally, or even death.
The solution is to improve air circulation. If too tight (too little air holes), create a new hole with a hole using a drill. If possible, add a cooling fan inside, or place the cooling fan-shaped drive that can be installed on 5 ¼ inch bay.

Chassis front panel lock is not perfect.
If the chassis front panel lock is not perfect, the problem is not designed to lock the panel well.
The solution is to add booster knob lock, using a cloth or glue. When the screw-shaped panels, use the appropriate screws and key meetings.

Power button hard to operate.
When the power button hard to operate, the problem or switch power connector on the front panel is not connected to a switch inside the chassis frame.
The solution of the front cover panel and tighten the chassis so perfectly locked. If necessary, you can extend the power switch button so that the switch can connect perfectly with the switch inside the chassis frame when the button is pressed on the front panel.

The power button can not be returned to its original position.
If the power button can not be returned to its original position, the spring switch power problem was weak or not sit perfectly.
The solution with new dressing, or a spring is slightly stretched. If the button does not sit perfectly, check all of the holder and position it in a fit